';

QUICKSTART GUIDE

So you’ve received your new Mobius Trimmer M108, unpacked it, and are ready to go. Great! This Quick Start video will get you trimming as fast as possible.

Watch the video, or view the step-by-step guide further down the page. Hover over each photo to see process.

Download this guide

STEP 1

Push down each of the 4 castors. Ensure all of the wheels are locked in place.

STEP 2

Push the plug into the receptor and rotate it slightly to the right.

STEP 3

Plug in the Trim Tote sensor wire to the body of the M108. Take note- the plug is NOT omni-directional.

STEP 4

Double check that the lid is latched properly by pulling up on it.

STEP 5

Ensure that the air pressure in the AirThread Tension Tumbler is between 130 – 140psi.

STEP 6

Install the nylon exhaust filter in the opening beside the Trim Tote.

STEP 7

If you’re going to use conveyors, place your conveyor sensor override pucks on the bumpers.

STEP 8A

Or install your input hopper…

STEP 8B

and output chute.

STEP 8C

You’ll see each of the error lights associated with the hoppers on the control panel go out once these or the pucks are installed.

STEP 9A

The emergency stop will be pushed in. Turn right to release.

STEP 9B

You’ll see the lights on the machine change from red to blue.

STEP 10

Adjust tilt to desired height by rotating the tilt knob towards the left. The legs will extend down from the front of the machine and the M108 will lift off the floor on one side.

STEP 11A

Hit the green START button.

STEP 11B

You’ll see the lights on the machine change from blue to white, indicating it is ready to go.

STEP 12

Pull out the blade speed, tumbler speed, and fan speed dials on the Variable Function display. Turn to the desired settings.

That’s it! You’re ready to start running product through your M108. If you have any questions about this process, don’t hesitate to get in touch with us, or view some of the other guides and videos we’ve made available in our Mobius Academy training site.

logo