In this video, we’ll show you how to properly connect your M108s in a tandem configuration.
Watch the video, or view the step-by-step guide further down the page.
Watch the video, or view the step-by-step guide further down the page.
Start by positioning the two units front to back.
Then, remove the conveyor sensor over ride pucks.
For stability, lock the wheels on the outfeed unit.
Raise outfeed unit to full height.
Open both lids.
Place tandem locks on the outfeed unit conveyor sensors.
Move infeed unit and align as close as possible.
Lower outfeed unit until it sits against infeed unit.
Lock the wheels on the outfeed unit.
Rotate the tandom locks inward until the handles are pointed down.
On the control panel of the infeed unit, raise to the desired height.
Close the lids, and you’re ready to trim!
info@mobiustrimmer.com
orders@mobiustrimmer.com
Contact Form
Service / Warranty Submission